Leave Your Message

China Lamella Clarifier | Waste Water Treatment Suppliers & Factory for Efficient Settling Solutions

The Lamella Clarifier Inclined Plate Settler (IPS) is a highly efficient solution for removing particulates from liquids, commonly utilized in primary water treatment processes as an alternative to traditional settling tanks. Manufactured by trusted suppliers in China, our factory specializes in advanced water purification technologies, This innovative method utilizes inclined tubes and plates set at a 60-degree angle, allowing the sludge suspension layer to collect efficiently above these structures. As raw water flows through, suspended particles settle on the bottom surface of the inclined tubes, forming a thin layer of sludge. Thanks to gravity, this sludge naturally slides back into the suspension layer, where it sinks into a mud collecting bucket. The collected sludge is then discharged through a mud discharge pipe for further treatment or reuse, Meanwhile, the clarified water rises to a collection pipe situated above, making it ready for direct discharge or re-utilization. Trust our China-based factory and suppliers for cutting-edge solutions that enhance water treatment efficiency and effectiveness

    Features

    • Maximized sedimentation area within limited footprint.
    • High-rate clarifier for high SS water (grit, clay, lime & mental particles).
    • Circular sludge hopper with sludge scraper to reduce total transportation height.
    • Indoor or outdoor layout (environmental temperature should be over 0°C).
    • Apply to automatic & continuous operation.
    • Design life: Carbon steel material: >10 years; Stainless steel material: >20 years.
    Lamella-Clarifier-3h60

    Advantage

    Higher efficiency, smaller footprint

    Inclined plates extended to 1.5m, separation efficiency improved (higher 1.5 ~ 2.0 times) comparing with radial flow clarifier and vertical clarifier and save 80% of area.

    Excellent hydraulic conditions

    No hydraulic corner and vortex, better precipitation performance.

    Inclined plates Chokeless

    Plates are of angle 60 degrees, spacing between 80 ~ 100 mm, back-washing device used.

    Strong and durable

    Inclined plates are breakless, collapseless. Adopt 6mm hard PVC board or 8 mm high quality PP board as special separation plate, module embedded installation, high strength, easy disassembling and maintenance.

    Sludge discharge smoothly

    No dead angle, sludge pump is recommended.

    Frequently Asked Questions

    Q: What is the expected design life of the Lamella Clarifier?

    The design life depends on the materials used: over 10 years for carbon steel structures and over 20 years for stainless steel structures.

    Q: How does the Lamella Clarifier save footprint space?

    By utilizing inclined plates extended to 1.5m, it maximizes the sedimentation area within a limited footprint, saving up to 80% of the area compared to traditional radial flow and vertical clarifiers.

    Q: What kinds of materials are used for the inclined plates?

    We adopt 6mm hard PVC boards or 8mm high-quality PP boards as special separation plates. They are installed via module embedding, making them breakless, collapseless, and highly durable.

    Q: What environmental conditions are required for installation?

    The system supports both indoor and outdoor layouts. However, for outdoor installations, the environmental temperature must remain above 0°C.

    Q: How does the system prevent clogging and ensure smooth sludge discharge?

    The inclined plates are angled at 60 degrees with a spacing of 80 to 100 mm and are equipped with a back-washing device to prevent choking. Additionally, a circular sludge hopper with a sludge scraper and a recommended sludge pump are used to discharge sludge smoothly without dead angles.